
Savannah Roof Pros provides professional fascia & soffit in Savannah, GA for residential and commercial properties across the Coastal Empire. On most houses the eave is trim. On an old Savannah house it is architecture. The boxed cornices, brackets, dentil courses and modillion blocks along these eaves are named among the character-defining features the city's ordinance protects, which puts fascia and soffit work in a different category here.
That is why we treat this as millwork rather than carpentry. When a section of cornice has gone, the replacement gets milled to the existing profile from a template taken off the sound run alongside it, in a species and grain orientation that behaves the same way. Stock trim from a lumberyard does not match, and on a contributing building matched versus approximate decides whether the repair is approved.
The rot itself almost always starts above. Fascia does not fail from weather on its face, it fails because the gutter behind it has been overflowing, because the edge metal was never hemmed to throw water clear, or because a valley terminates short and discharges behind the gutter line every time it rains hard. Replacing the board without fixing what wetted it buys you three or four years and the same conversation again.
We argue firmly against wrapping historic cornices in aluminum or vinyl. It is sold as maintenance-free and it is the opposite. The wrap conceals whatever is happening to the wood underneath, holds moisture against it in a climate that supplies plenty, and on a protected building it changes a visible material and flattens detail that took a craftsman a day to cut. We have pulled coil stock off Savannah eaves and found nothing left behind it.
Soffits carry a second job worth protecting, which is intake air. Original boxed soffits often have vents that have been painted shut over decades, or insulation crammed into the eave bay above them, and restoring that path is the cheapest attic improvement available on most of these houses. Where new venting is needed we place it on the underside where it does nothing to the roofline and nobody has to approve it.
Outside the districts the job is simply the job. On a Pooler or Hinesville house, a rotted fascia run and a torn vinyl soffit get replaced efficiently in matching material and the whole thing is done in a day. We are not going to invent complexity where none exists, and we will tell you plainly which kind of building you have before we quote it.
Our licensed and insured team brings the right materials and equipment to every job — standing-seam and flat-lock terne metal with concealed clips, through-wall counterflashing let into lime mortar joints, half-round copper gutter with round downspouts, one-by-six board sheathing over open rafters, Certificate of Appropriateness submittals to the Historic District Board of Review, self-adhered high-temperature underlayment at eaves and valleys — and backs the work with a written workmanship warranty. We serve Savannah and nearby communities including Pooler, Garden City, Port Wentworth, Thunderbolt.
What We Handle
Everything our fascia & soffit in Savannah covers
One crew, one point of contact, and the full range of fascia & soffit work in Savannah, GA. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia repair savannah
- soffit repair savannah ga
- rotted fascia board replacement
- boxed cornice repair
- wood soffit replacement
- aluminum fascia wrap
- eave repair savannah
- cornice millwork restoration
- soffit vent installation
- fascia and soffit contractor savannah
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Savannah services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with standing-seam and flat-lock terne metal with concealed clips, through-wall counterflashing let into lime mortar joints, half-round copper gutter with round downspouts, one-by-six board sheathing over open rafters, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Savannah job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the Coastal Empire means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Savannah
Savannah Roof Pros covers Savannah and the surrounding communities of the Coastal Empire. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Pooler, GA — Chatham County, population 25,711
- Fascia & Soffit in Garden City, GA — Chatham County, population 10,289
- Fascia & Soffit in Port Wentworth, GA — Chatham County, population 10,878
- Fascia & Soffit in Thunderbolt, GA — Chatham County, population 2,556
- Fascia & Soffit in Tybee Island, GA — Chatham County, population 3,114
- Fascia & Soffit in Bloomingdale, GA — Chatham County, population 2,790
Start on the Savannah Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Savannah Chooses Savannah Roof Pros
- ✓We tell you at the first visit whether your address needs a Certificate of Appropriateness, in writing, before any pricing
- ✓Salvaged slate, matching tile and flat-lock pans kept on hand so a small repair on a protected roof stays a small repair
- ✓Attic moisture readings on every inspection, because a good share of Savannah leak calls turn out to be condensation
- ✓Half-round and K-style gutter both quoted, with an honest explanation of which profile suits your building
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Savannah follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Savannah gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Savannah, or request a quote and we'll get right back to you.